Single-Channel Emulation Encoder - revision 'K'

I've just added a simple but useful update to the Single-Channel Emulation Encoder. After a low pass at half-throttle, I've occasionally found that I'd miscounted my quick-blips and while I was expecting the next blip to open the throttle and to climb away, what actually happened was the next step was low throttle and the low pass became an unplanned landing ;) If you recall, the yellow LED indicates the selected throttle position - off for low, on for full, and at mid throttle the yellow led used to flash steadily. What it gives now at mid-throttle is a [i]slow[/i] flash if the next blip is low throttle, and a [i]fast[/i] flash if the next blip is high throttle. Simple but very handy - during a half-throttle pass, you now know with a glance at the tx which throttle setting comes next. This is version K and will probably be the last update ;) I know a few are still using older firmware, which is fine, there are no problems with any of the versions, but I think the recent additional features are well worth having. Heres a version list showing the last few upgrades: 28A added additional slow-sweep range test mode in addition to the flip-flop movement 28B added a config setting for choice of 2 or 3 position throttle (hi/mid/low/mid) 28C added LED red/green mix on kick-up elevator, added range sweep LEDs 28D in compound mode, when 3-position throttle is selected, flash the yellow LED at 1/2 throttle 28E playing with generating escapement noises from the buzzer. Not concluded, not issued. 28F clear motor run timers after a run. Have to be reset before next flight. Its a Safety thing. 28G clear motor run timer bits when changing config from compound to sequential, again a Safety thing 28H in compound mode, mid-throttle can be set from 1.2 to 1.7ms rather than fixed at 1.5ms 28i in sequential mode, auto motor start replaced with manually motor start by holding button for 5 secs. 28J in sequential mode, sound warning pips whilst motor is primed ready to run 28K in compound mode, at mid throttle, motor LED flash rate indicates next QB motor speed I was wondering, as there are quite a few of the S/C sets out there now, could I ask that pics are returned with an SAE and I'll upgrade them FOC by return. Cheers Phil