etrailer | All About the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package-C56357
Click for more info and reviews of this CURT Custom Fit Vehicle Wiring: https://www.etrailer.com/Custom-Fit-V... Check out some similar Custom Fit Vehicle Wiring options: https://www.etrailer.com/fitguidet1.htm https://www.etrailer.com Don’t forget to subscribe! / etrailertv Full transcript: https://www.etrailer.com/tv-Demo-Curt... Today we're going to take a look at the CURT T-Connector Vehicle Wiring Harness with the seven-way trailer connector for factory tow packages. Now this is a custom fit part. It is designed to fit the 2013 and newer Nissan Pathfinders and the 2014 and newer Infiniti QX60s. Now on a custom fit part I'd also like to recommend for you to go to our website, use our fit guide. Put in your year and model vehicle and it will show you if this will work for your application. This will provide a seven-way blade-style trailer connector right here at the back of your vehicle to power your trailer's signal lights. Again this is designed for vehicles with the factory tow package. It is compatible with four-pole, five-pole, and six-pole adapters we sell separately on our website. This whole harness connects very quickly and easily. There's no cutting or splicing of wires. Basically, you just locate your connection points underneath the rear cargo storage unit to plug this one in, and behind the rear bumper to plug this one in. You'll plug in the connectors with all the relays and you're all ready to go. It does include everything shown here on the table. It includes the relays. It includes a nice set of detailed instructions that shows you where the locations are to install everything. Comes with three pieces, if you pull that tape off, these three pieces of foam you can put around these relays to keep them from making any noise, and also some extra cable ties to take up any slack in the wiring. This part is made in the USA. If you notice, the seven-way does come with a nice spring-loaded dust cover for a seven-way connector. The specs on this harness, the maximum amperage is 10 amps total for each circuit: the stop-turn light circuit, the taillight circuit, and the backup circuit. Now to install this, it's very quick and simple. What you'll do is take this relay harness. Then you'll take two of the blue ones and install them right here, and then take the brown relay and you'll have all three relays installed in here. Then you'll go under the rear cargo storage unit and you'll find connectors that will match this. As I mentioned, to keep these from bouncing around you can use these foam pads around them to keep them from making any noise. Then what you'll want to do is this seven-way is going to be attached at the back of your vehicle. What you'll want to do is go ... a custom wiring connector, this portion here. This will connect to connectors that are on the vehicle behind the rear bumper. Then you take this other end, and it will plug right into your seven-way that will be installed at the back of the vehicle. Then the last thing you need to do, you'll have two remaining blue relays. Those two, what you'll do is you'll go to the hood of the vehicle, open your front hood, and there's a relay box that's behind the driver side headlight. Then there's a spot. You open that relay box, there's a spot for these two last relays to go in. Once everything's installed, you're all ready to go and you'll have a seven-way connection at the back of your vehicle. That should do it for the review on the CURT T-Connector Vehicle Wiring Harness with the seven-way trailer connector for factory tow packages.
