etrailer | Curt T-Connector Wiring Harness Reivew

Click for more info and reviews of this CURT Custom Fit Vehicle Wiring: https://www.etrailer.com/Custom-Fit-V... Check out some similar Custom Fit Vehicle Wiring options: https://www.etrailer.com/fitguidet1.htm https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-review-cu... All right, today we're going to review the Curt T-Connector Vehicle Wire Harness with a 4-pole flat trailer connector, part number 56020. This is what comes with the part number, obviously your wire harness right here and your 4-pole end. The 4-pole end right here also comes with a cover to protect it when it's not being used. It has a very long length of wire going up to your two T-connectors. One T-connect here at the green wire, that goes up to the passenger side tail light and the yellow wire goes up to your driver's side tail light. They're easy to install, no cutting or splicing into your factory wire harness. You do have to remove some tail lights and maybe some few interior panels to run your wires, but that's about it. It comes with a little bag with some zip-ties as well. Also it comes with a little self-tapping screw, typically that's used for wire harnesses that uses a ground from the sheet metal behind the tail light. In this case, our wire harness actually uses the ground wire that's pre-existing in the wire, so we don't have to use any power tools to attach your ground on this wire harness. Okay, and with that, that will finish it for the Curt T-Connector Vehicle Wire Harness with a 4-pole flat trailer connector, part number C56020.