How to Replace Rear Brake Light – Toyota Sienna (2003-2009)

Brake Light #7443 - https://amzn.to/3zm8w7n (tail/brake light - dual filament) The other bulbs used in this cluster: Turn Signal #7440 - https://amzn.to/42yhZmm (turn signal light - single filament) Reverse Light #921 - https://amzn.to/3G8MIPv Side Marker #194 - https://amzn.to/3RkZBZ9 In this video, we'll walk you through the simple process of replacing the rear brake light on a 2006 Toyota Sienna. The same process should apply for 2003-2009 Toyota Siennas. Tools & Parts Needed: 10mm socket wrench Replacement bulb: Part #7443 (https://amzn.to/3zm8w7n) We also share some helpful tips to avoid breaking plastic snaps when removing the light housing, which can save you time and frustration. You'll go through exactly how to remove and replace the burnt-out brake light bulb without damaging your vehicle. Here’s a quick overview of the steps: Open the rear trunk. Remove the two 10mm bolts holding the light fixture. Carefully pull the light housing outward, parallel to the wheel axles. Remove the old bulb and replace it with a new one (Part #7443). Reassemble the light fixture and tighten the bolts. Replacing a brake light is a quick and essential fix to avoid getting pulled over. Make sure both brake lights are functioning properly for your safety on the road. If this video helped you, be sure to leave a comment, and don’t forget to subscribe for more DIY automotive repair videos. Chapters: 0:00 Introduction 0:20 Pro-tip on Removing Light Housing 0:50 Tools Needed 1:08 Removing the Light Housing Fixture 2:03 Replacing the Brake Light Bulb 2:57 Reassembling the Light Fixture 3:55 Final Check and Conclusion Please subscribe and hit the notification bell, it is appreciated. For more helpful tutorials, visit: PracticalMechanic.com I may earn commissions for purchases made through the links. As an Amazon Associate, I earn from qualifying purchases.