Speed Queen Washer How-To Load

http://docs.alliancelaundry.com/tech_... top-load Washer Speed Queen TR7 error code Topload Washer Display Description Cause/Corrective Action Er and nr Drive Not Ready Error Output board is not ready within one minute. Replace the output board. To clear this error the machine must be powered down. Ed and XX Output Board Error Error received from the output board. Inspecting wire harnesses to output board. Replace output board if wiring is not damaged. To clear this error the machine must be powered down. Er and bS Board Shorted Error Output board enable relay is shorted. Replace the output board. To clear this error the machine must be powered down. PF Delay Start Power Fail Error Machine experienced a long power fail or has been unplugged during Delay Start Mode. No service should be needed. Press Power/cancel to continue normal operation. IN USE LED blinks twice + 1.5 second pause Fill Error A Fill Error will occur if the tub does not fill within 62 minutes of the start of the cycle. A Fill Error is indicated by the control repeatedly flashing the IN USE LED twice separated by a one and a half second pause until the control is powered down. If Error Mode is turned off, the fill error will not occur and the control will continue to wait for the fill level to be reached. IN USE LED blinks three times + 1.5 second pause Drain Error A Drain error will occur if the tub is not empty after a spin cycle. A Drain Error is indicated by the control repeatedly flashing the IN USE LED three times separated by a one and a half second pause until the control is powered down. If Error Mode is turned off, the drain error will not occur and the machine cycle will advance to the next cycle step as though the water had been pumped out. OFF or oFF Break-in Alarm Shutdown Error Service door or coin vault switches. Right most DP (decimal point) Lit Network Communication Error Communication failure. Wait for 1.5 minutes for error to clear. If it doesn’t, power-down and power-up the machine. If error persists, control or Network Board may need to be replaced